ADC H2TU-C-231 - Manual (Page 23)

LTPH-UM-1109-01, Issue 1 Provisioning
H2TU-C-231 List 2 January 9, 2002 15
Configuring the System
The Config menu ( Figure 6 ) allows you to make the following types of system configuration changes:
• Standard options ( Figure 7 on page 16 )
• ADC options ( Figure 8 on page 16 )
• BERT Generator ( Figure 29 on page 52 )
• Date and time (see “Setting Date and Time” on page 13 )
• Master clear (see “Clearing the History, Alarm, and Event Log Screens” on page 23 )
• Reset to factory default configuration (see “Resetting to Factory Default Values” on page 10 )
Figure 6. Config Menu
Making Changes to Standard and ADC Options
Figure 7 and Figure 8 on page 16 show the Standard and ADC configuration options. Standard options are those
supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set
of options that are only available when using HiGain HDSL2 units exclusively. For a description of each option
and a list of possible option settings, refer to
Table 5 on page 17 and Table 6 on page 18 . To make changes to these
options:
1 Press to select the Config menu.
2 Use the and arrow keys to select Standard Options or ADC Options, then press .
3 Use the arrow keys to select an option.
4 Press the to cycle through the available settings for that option.
5 Press to activate your choice.
Monitor Performance Event Log Config Inventory Report Rlogon Help
+----------------------+
|
Standard Options -> |
| ADC Options -> |
| BERT Generator -> |
| Date and Time -> |
| Master Clear |
| Set Factory Defaults |
+----------------------+
ID: xxxx--xxxx—-xxxx--xxxx 09/01/2001 12:30:01 H2TU-C System: OK ___
C
↑ ↓ ENTER
SPACEBAR
ENTER