ROTHENBERGER WALL CUT 6540 User Manual
Page 15
ENGLISH
13
Caution: Electric lines, gas and water pipes in the walls. Be sure to check for these lines and
pipes, e.g. using a metal detector!
Caution when cutting into supporting walls! Slits in supporting walls are subject to part 1 of
the DIN 1053 standard or country-specific regulations. These regulations are to be adhered to.
Please consult the responsible stress analyst, architect or competent site engineer before
beginning work. The depth and width of the slit depend on the wall thickness and the building
material used.
2
Technical Data
Voltage ....................................... 230 V, 50/60 Hz
Capacity ..................................... 2400 W
Rated speed ............................... 6600 min-1
Cut-off wheel bore ...................... 22.2 mm
Cut-off wheel diameter ................ 230 mm
Depth of cut ................................ 20 – 65 mm
Width of cut ................................. 5 – 40 mm
Weight ........................................ 9.8 kg
Protection class .......................... II
Typical A-rated sound level:
Noise pressure level ............. 93 dB (A)
Sound power level ................ 106 dB (A)
Vibration ..................................... 4 m/s²
The noise level can exceed 85 dB (A) when working. Wear hearing protection! Measured values
determined in accordance with EN 60 745.
3
Function of the Unit
3.1 Description
The WALL CUT 6540 wall slit milling cutter is equipped with a starting current limiter, safety
switch, a protective cover fastener with safety notch and a spindle locking device for quick cut-
off wheel change.
Further performance features include rotatability of the handle, fitted with a carbon brush
replacement flap and a motor with two coil protection grids offering optimal protection against
abrasive dust.
Simultaneous use of two diamond cut-off wheels allows slits up to a maximum depth of 65 mm,
adjustable for slit widths of 5 – 40 mm, installation channels and cable ducts can be milled
exactly down to the last millimetre.
Quick and simple removal of the remaining centre bar using the provided slitting chisel. The vast
cutting performance and dust removal guarantee a fast and clean working result.
3.2 Overview
A
1
Safety on/off switch
7
Locking lever depth adjustment
2
Disabling button
8
Additional handle
3
Mains cable
9
Depth adjustment
4
Protective cover with scale
10
Rollers
5
Carbon brush replacement flap
11
Spindle locking device
6
Connecting piece dust remover
12
Switch (rotatable handle)