A.J. Antunes & Co DCH-22 9020485 - Manual (Page 10)

DISPLAY CABINET HEATED
9 P/N 1010677 Rev. D 12/99
A.J. Antunes & Co.
Figure 6. Display Lamp Replacement
FRONT DISPLAY GRAPHICS OR LAMP REPLACEMENT
1. Turn rocker switch to the OFF position.
2. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
4. Using a screwdriver or similar flatbladed tool,
gently pry one side of the display panel assembly
from the unit (Figure 6), then remove the panel.
5. DCH-10/12: Remove lamp by gently turning it
counterclockwise. Install a new lamp.
DCH-20/22/30/32: Remove fluorescent tube by
gently turning it up and out of the sockets.
Remove bulb deflector and install on new tube,
then install tube into unit.
6. Install new graphics by removing the white dif-
fuser plate and transparency holder. Replace
transparency and reinstall holder and plate.
REAR DOOR REPLACEMENT
DCH-10/12 Models
1. Turn rocker switch to the OFF position.
2. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Open the rear door and lift off the hinge pins.
4. Place new door on hinge pins and slide door
down into track.
DCH-20/22/30/32 Models
1. Turn rocker switch to the OFF position.
2. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Firmly grasp the sides of one glass door. Lift the
door up and out of the bottom track. Repeat for
the other door.
4. Place new door in the inside upper track. Push
up firmly and slide bottom of door into bottom
inside track. Install other door into outside tracks
the same way.
DCH-10/12
DCH-20/22/30/32
Figure 7. Rear Door(s) Removal/Installation