Display cabinet heated, Installation – A.J. Antunes & Co DCH-22 9020485 User Manual

Page 7

Advertising
background image

DISPLAY CABINET HEATED

6

P/N 1010677 Rev. D 12/99

A.J. Antunes & Co.

Figure 1. Display Components (DCH-10 Shown)

Unpacking

1. Remove unit and all packing materials from ship-

ping carton.

2. Open the large box. Remove all packing materi-

als and protective coverings from the unit and
parts.

NOTE: If any parts are missing or damaged, contact
Antunes Technical Service IMMEDIATELY at 1-877-
392-7854.

3. Wash all components in soap and water. Wipe all

surfaces of the unit with a hot damp cloth.

NOTE: Do not use a dripping wet cloth. Wring out
before use.

4. Install components in unit.

Equipment Setup

When placing the unit into service, pay attention to the
following guidelines.

• Make sure power to the unit is off and the unit is

at room temperature.

• Do not block or cover any openings on the unit.

• Do not immerse cord or plug in water.

• Keep cord away from heated surfaces.

• Do not allow cord to hang over edge of table or

counter.

• Place unit on a sturdy, level table or work surface.

• Ensure that the line voltage corresponds to the

stated voltage on the unit specification label.

• Turn off the rocker switch. Connect the unit to the

power supply.

INSTALLATION

CAUTION

All electrical connections must be in accordance
with local electrical codes and any other applica-
ble codes.

WARNING

ELECTRICAL SHOCK HAZARD. FAILURE TO FOL-

LOW THE INSTRUCTIONS IN THIS MANUAL

COULD RESULT IN SERIOUS INJURY OR DEATH.

Electrical ground is required on this appliance.

Do not modify the power supply cord plug. If it
does not fit the outlet, have a proper outlet
installed by a qualified electrician.

Do not use an extension cord with this appli-
ance.

The unit should be grounded according to local
electrical codes to prevent the possibility of
electrical shock. It requires a grounded recep-
tacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.

Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.

Water Tray

Diffuser

Heat Shield

Advertising