A.J. Antunes & Co DCH-22 9020485 - Manual (Page 11)

DISPLAY CABINET HEATED
10 P/N 1010677 Rev. D 12/99
A.J. Antunes & Co.
MAINTENANCE (continued)
FRONT GLASS PANEL REPLACEMENT
1. Turn rocker switch to the OFF position.
2. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Loosen the screw securing each top glass retain-
er. Slide retainer up and to the rear.
4. Tilt front glass panel assy. forward on the hinge
plate and remove from unit.
5. To reinstall, be sure glass panel assy. is fully seat-
ed in hinge plate, then tilt panel assy. fully rear-
ward. Secure with top retainer and tighten
screws.
SIDE GLASS REPLACEMENT
1. Turn rocker switch to the OFF position.
2. Unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Remove the screws securing each top retainer
and remove retainers.
4. Tilt front glass panel assy. forward on the hinge
plate and remove from unit.
CAUTION
Front glass panel replacement should be per-
formed by two people to prevent damage to the
glass.
Figure 7. Glass Panel (s) Replacement
Top Glass
Retainer Assy.
Front Glass
Panel
Top Cap
Assy.
Side Glass
5. Remove both top cap assys.
6. Lift side glass panel up and forward to remove it
from the glass clips.
7. To reinstall, position side glass panel into glass
clips. Push fully rearward. Reinstall front glass
panel assy.
8. Secure with top caps and retainers. Tighten
screws.