AccuTemp Steam N Hold - Manual (Page 8)

STEAM’N’HOLD™ MP4002-1103 8 of 17
BuILDING CODES AND STANDARDS
The appliance must be installed in accordance
with the following building codes:
USA: National Electric Code, ANSI/NFPA-70,
state and local codes. International Plumbing
Code 2003, ICC or Uniform Plumbing Code
2003, IAMPO. Canada: Canadian Electric Code,
CSA C22.2 and state and local codes.
uNPACKING
This appliance was inspected before shipment
from the factory. The shipping company accepts
full responsibility for safe delivery. Immediately
after unpacking, check the appliance for possible
shipping damage. If damage is identified, save
the packaging material and contact the shipping
carrier within 15 days.
LOCATION AND PLACEmENT
To insure maximum benefit of your warranty;
location, placement and leveling are critical.
The AccuTemp STEAM’N’HOLD™ is designed
for installation on either a commercial kitchen
counter top or an AccuTemp STEAM’N’HOLD™
stand. Your appliance is equipped with vents to
allow the proper ventilation of air through the
electrical compartment. The vents are located on
the bottom and rear panel. To ensure these vents
work properly a minimum 3” (77 mm) clearance
from these vents must be allocated. It is also
recommended that the appliance not be placed
under other wet equipment or locations.
LEVELING
This appliance must be installed in a level
condition. An out-of-level condition may cause
improper operation and possible damage. Damage
caused by improper leveling is not covered by
warranty. Use a spirit level, resting on the top of
the appliance cabinet surface, to ensure it is level
front-to-back and left-to-right. If this is a counter-
top installation, be sure to install the rubber foot
tips provided with your appliance onto each foot
SINGLE STAND INSTALLATION
The AccuTemp SNH10 single stand is equipped
with adjustable height feet and the AccuTemp
SNH11 single stand is equipped with non-
adjustable height casters. Both can be used with
either a single S3 or S6 model STEAM’N’HOLD™.
Before mounting the appliance on the SNH11
stand, engage the brakes on the two front locking
casters, pressing on the “ON” handle of the brake
mechanism. To mount the appliance, carefully
lift and place it on the horizontal mounting
brackets, ensuring that the (4) mounting holes on
the underside of the appliance is lined up with
the mounting holes on the brackets. Then, using
a 7/16” wrench, fasten one pair of the ¼”-20
hex bolts and ¼” split lock washers through the
underside of each stand bracket mounting hole
into the appliance and tighten securely. With the
SNH10 stand, level the appliance by adjusting the
feet found at the ends of each stand leg, either up
or down as needed.
INSTALLATION
adjuster of each of the legs. This will keep the
appliance from sliding on the counter-top under
normal use. Once the rubber foot tips have been
installed, rotate the foot adjusters up or down as
needed to level the appliance
DOuBLE STAND INSTALLATION
The AccuTemp SNH20 double stand is
equipped with adjustable height feet and the
AccuTemp SNH21 double stand is equipped
with non-adjustable height casters. Both stands
can accommodate either two S6 models or two
S3 models or a single S3 model on the top and
a single S6 model on the bottom.
Before mounting a appliance on the SNH21
stand, engage the brakes on the two front
locking casters, pressing on the “ON” handle of
the brake mechanism. To mount the appliance,
carefully lift and place it on the bottom
horizontal mounting brackets, ensuring that
the (4) mounting holes on the underside of the
appliance are lined up with the mounting holes