Karcher SB V1 Eco - Manual (Page 27)

– 12
– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to IEC
60364-1.
– The voltage indicated on the type plate
must correspond to the voltage of the
electrical source.
For proper installation of the appliance,
please take care of the following points
– There must be a horizontal, even sur-
face with minimum dimensions of
900 mm x 900 mm.
– Power supply according to measure-
ment chart (X), see Appendix.
Caution
Select the installation site in such a way
that the exhaust air cover and the air supply
channel are always kept open to protect the
machine against over-heating.
Î
Drill 3 fastening holes d=12 mm, 43 mm
depth according to measurements
chart.
Î Open device door.
Î Remove transport lock.
Î Remove vacuum cleaner and suction
hose from the appliance casing.
Caution
Risk of injury due to machine toppling over.
The machine must be installed and fas-
tened with screws on a firm, solid base.
Fasten the appliance using the enclosed
fasteners:
Î
Insert the dowel (5) in the drilled holes.
Î Place the appliance at the proposed
site. Guide the cable for the electrical
connection through the opening in the
base of the appliance.
Î Insert covers (1) in the base plate of the
appliance (4).
Î Insert the discs (2) as shown in the
drawing.
Î Insert the screws (3) and tighten it with
a tightening torque of 20 Nm.
Device installation
Only for authorised technicians!
Electrical connection
Preparing the installation place
!
Install the device and align it
27 EN