AMX 8.5" Color Passive LCD Touch Panels - Manual (Page 10)

Installation
6 Color Passive-Matrix LCD Touch Panels
11. Test the connection by reconnecting the AXlink connector to the Central Controller and the
optional RS-232 wiring to the source equipment. The panel beeps upon power-up. Before
continuing, disconnect all connections until panel installation is complete.
12. Fasten the touch panel to the BB-TP2 using the #6-32 screws supplied with the panel.
13. Place the Decor-style faceplate onto the bezel. You can also secure the faceplate to the bezel
using the four Phillips flat-head security screws.
14. Remove the backing from the adhesive tape strips on the touch panel; press the engraved
overlay onto the faceplate. Once attached to the faceplate, the security screws cannot be
replaced without removing the battery.
15. Reconnect the AXlink wiring to the Central Controller and RS-232 wiring (optional) to the
external RS-232 device. The touch panel will beep when you apply power.
Installing touch panels and a BB-TP2 Back Box (plasterboard)
FIG. 4 shows the AXD-CP/PB and BB-TP2 Back Box for plasterboard.
1. Cut out the surface using the dimensions shown in FIG. 5.
2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel's faceplate and
remove the engraved overlay.
3. Lay the touch panel facedown onto a soft cloth and remove the screws from the low-profile
Back Box. Remove the Back Box and discard.
4. Place the BB-TP2 into the cutout and mark the threaded insert positions (FIG. 4).
5. Remove the BB-TP2 and drill four #6-32 insert holes. Then, place a threaded insert (or screw
anchor) into each hole.
6. Disconnect the AXlink connector from the Central Controller that supplies power and data to
the touch panel. Then, disconnect the optional RS-232 wiring from the external RS-232 device
connected to the touch panel.
7. Remove one or more knockouts to accommodate the wiring as required.
FIG. 4 AXD-CP/PB and BB-TP2 Back Box (plasterboard)
BB-TP2 Unimount
Backbox enclosure
Knockout
Plasterboard surface mounting flanges
Engraved overlay
AXD-CP/PB
faceplate
Expansion clips