Karcher KMR 1250 Lpg - Manual (Page 36)

English
User Instructions
KMR 1250 LPG
36
Typical applications
!
Caution while sweeping!
Do not sweep up packing bands, wires or similar items, otherwise the
sweeping mechanism will be damaged.
Do not sweep any burning/glowing objects.
Sweeping on dry ground
If there is a large amount of rubbish, such as several layers of leaves
n
remove the bulk by hand before you start with the sweeper.
For a small amount of normal dirt
on an even surface:
n
lower main brush
– set the lever to the middle position
(minimum brush wear).
on an uneven surface:
n
lower main brush
– set the lever to the lower position (increased brush wear).
n
switch on dust extraction
– set the switching mode lever to dry
n
for cleaning right up to the edges – lower the side brush .
At regular intervals:
n clean the filter,
n
empty the waste hopper.
Notes: If you are sweeping up fine dust, use the side brush as little as possi-
ble as it will increase the amount of dust stirred up by the sweeper. If the
side brush encounters an obstacle, it automatically swivels back inside the
outer contours of the sweeper. You should nevertheless try to avoid collisi-
ons.
While the sweeper is operating, the filter should be cleaned approx. every
15–30 minutes (depending on amount of dust).
Sweeping on damp or wet ground
Follow the same procedure as for sweeping on dry ground. In order to protect
the filter from moisture
n
switch off the dust extraction
– set the sweeping mode lever to wet .
At regular intervals:
n
empty the waste hopper.