Sony TDM-NC1 - Manual (Page 17)

17 GB
Case A: Wired connection
1
Connect the unit to the network using a
wired connection.
Connect the unit to your router (hub) or
directly to the LAN port of the computer.
Use the network cable (not supplied).
Check that the WIRELESS/WIRED
selector on the unit is set to WIRED.
Notes
• When using the unit with a fixed IP address,
refer to “Advanced Network Settings”
(page 31).
• When connecting the unit to the computer
directly, set the IP address of computer to
“Automatic Private IP Addressing”. After
turning on the computer, “Configuring” appears
in the unit display window for a few minutes.
• In some cases, a message indicating that the
connection is limited, or not available, will
appear in the lower right portion of the
computer; however, the unit will operate
normally.
2
Turn on the AV system, and set the AV
system’s function to DMPORT.
3
Go to STEP 8 (page 20).
Case B: Wireless connection
(setting up by the unit)
1
Set the WIRELESS/WIRED selector on
the unit to WIRELESS.
2
Turn on the AV system, and set the AV
system’s function to DMPORT.
3
Confirm the settings of your wireless
system.
Check the following items of your wireless
LAN router to set the same information for
the TDM-NC1.
SSID (Wireless Network Name):
________________________________________
If your wireless LAN router security is
enabled,
Wireless Network Key:
__________________
Tips
• For details on how to check the wireless LAN
router settings, refer to the operation manual of
your wireless LAN router.
• In some case, SSID name and wireless network
key numbers/characters are often written on the
wireless LAN router.
• Check that your wireless LAN router uses the
latest firmware version. For details, refer to the
operation manual of your wireless LAN router.
4
Press MENU.
5
Press . or > repeatedly until “Wi-
Fi SETUP?” appears in the unit display
window, then press ENTER.
“SSID?” appears.
6
Press ENTER.
“Searching” appears.
7
Press . or > repeatedly until your
wireless LAN router SSID name
appears, then press ENTER.
If you set the wireless network key in the
wireless LAN setting, “KEY?” appears.
Press ENTER.
If you do not set the wireless network key,
the unit restarts, go to STEP 8 (page 20).
WIRELESS
WIRED
Network cable
(not supplied)
To router (hub)
or LAN port of
the computer To LAN port
WIRELESS/
WIRED selector