Sony TDM-NC1 - Manual (Page 18)

18 GB
8
Enter the wireless network key
numbers/characters.
Use . / > to choose the character,
m / M to skip entered digits.
Also you can choose letter types using +/–.
Letter types changes as shown below:
9
Press ENTER.
The unit restarts, go to STEP 8 (page 20).
Note
If you set wireless network key (WEP key) to
other than “WEP key No. 1”, you need to select
the Case C connection (page 18).
Case C: Wireless connection
(setting up by the computer)
1
Connect the unit to the network using a
wired connection.
Connect the unit to your wireless LAN
router (hub) or directly to the LAN port of
the computer. Use the network cable (not
supplied). Check that the WIRELESS/
WIRED selector on the unit is set to
WIRED.
Notes
• When using the unit with a fixed IP address,
refer to “Advanced Network Settings”
(page 31).
• When connecting the unit to the computer
directly, set the IP address of computer to
“Automatic Private IP Addressing”. After
turning on the computer, “Configuring” appears
in the unit display window for a few minutes.
• In some cases, a message indicating that the
connection is limited, or not available, will
appear in the lower right portion of the
computer; however, the unit will operate
normally.
2
Turn on the AV system, and set the AV
system’s function to DMPORT.
3
Confirm the settings of your wireless
system.
Check the following items of your wireless
LAN router to set the same information for
the TDM-NC1.
SSID (Wireless Network Name):
________________________________________
upper case y lower case
Y Y
space y symbol y number
WIRELESS
WIRED
Network cable
(not supplied)
To wireless LAN
router (hub) To LAN port
WIRELESS/
WIRED selector