Sony TDM-BT1 - Manual (Page 10)

10
GB
TDM-BT1 [GB] 3-095-404-11(1)
To finish connecting
Terminate the BLUETOOTH connection by any of the operations
below.
– Operate the BLUETOOTH stereo audio source device to terminate the
connection. For details, refer to the operating instructions supplied with the
device.
– Turn off the BLUETOOTH stereo audio source device.
– Press the OPR button momentarily. Until the disconnection is complete, the
LED status indicator flashes.
Note
In the following cases, you need to make the BLUETOOTH connection
again.
– The BLUETOOTH connection is disconnected once.
– The power of the BLUETOOTH stereo audio source device does not turn on, or
the BLUETOOTH signal is off.
– The BLUETOOTH stereo source device is in sleep mode.
– The BLUETOOTH connection is not made.
To turn off the BLUETOOTH signal
Even if you stop BLUETOOTH communication with the BLUETOOTH
stereo audio device, this unit continues to send out signals. You can stop
the signal completely by the operations below.
– When the LED is on:
Press momentarily the OPR button to stop BLUETOOTH communication with
the BLUETOOTH stereo audio device. Then press momentarily the OPR
button again to turn off the signal from the unit.
– When the LED is flashing:
Press momentarily the OPR button to turn off the signal from the unit.
Initializing
You can reset this unit to its default setting and delete all pairing
information.
If this unit is turned on, use a thin pointed object
(such as a paper clip) to press the RESET button to
initialize this unit.
The LED status indicator flashes twice, and this unit is reset to the
default.
All pairing information is deleted.
Note
If this unit is connected to a BLUETOOTH device, you cannot reset this
unit.