Sony TDM-BT1 - Manual (Page 8)

8
GB
TDM-BT1 [GB] 3-095-404-11(1)
1
Press and hold the OPR button for 3 seconds or more.
O P R
OPR
The LED status indicator starts flashing very quickly and this unit
enters pairing mode.
Note
Pairing mode is canceled automatically if pairing is not achieved within 5
minutes, or manually by pressing the OPR button. If pairing mode is canceled
midway, start over from step
1 .
2
Perform pairing procedure on the BLUETOOTH stereo
audio source device to detect this unit.
The list of detected devices appears on the display of the
BLUETOOTH stereo audio source device.
This unit is displayed as “TDM-BT1.”
If “TDM-BT1” is not displayed, repeat from step
1 .
Notes
• When pairing, be sure to place both the BLUETOOTH devices within 1 m
of each other.
• Some devices cannot display the list of detected devices.
• To operate the BLUETOOTH stereo audio source device, refer to the
operation instructions of the device.
3
Select “TDM-BT1” on the display of the BLUETOOTH
stereo audio source device.
4
If Passcode * input is required on the BLUETOOTH
stereo audio source device, input “0000”.
When BLUETOOTH pairing is complete, the LED status indicator
flashes slowly and pairing information is memorized on this unit.
* Passcode may be called “Passkey,” “PIN code,” “PIN number,” or
“Password.”
Notes
• Some BLUETOOTH stereo audio source devices may connect with the
unit automatically when pairing is completed. For other devices, you will
have to connect to this device manually.
• If you disconnect this unit or the BLUETOOTH stereo audio source device,
before a connection is complete, pairing information is not memorized, and
pairing will not be completed.