ADTRAN 203019L1 User Manual
Page 23
61203019L1-1
NT1 ACE User Manual
7
NT1 ACE User Manual
powered from the NT1, verify that the total power require-
ment of the connected TE is less than 8.9 watts.
To connect the NT1 ACE to the NT1 Power Supply, perform
the following steps as illustrated in Figure 4.
1. Connect the Power Supply to the NT1 ACE at the
POWER
jack located on the NT1 ACE.
2. Plug the Power Supply into the nearest wall outlet
supplying 110 VAC, 60 HZ.
3. On the NT1 ACE, verify that the POWER and ERROR
indicators are illuminated. After approximately 15
seconds, the READY indicator should flash at a 1 Hz
rate. Should any of the indicators fail to operate as
stated, see the section Troubleshooting on page 11.
Figure 4. Power Supply Connection
ADTRAN
ISDN PS2
LOCAL
NETWORK
POWER
1 0 0 - 1 2 0
VA C
READY
ERROR
POWER