ADTRAN 203019L1 - Manual (Page 24)

8 NT1 ACE User Manual 61203019L1-1
NT1 ACE User Manual
Connecting the Terminal Equipment
After successfully powering up the NT1 ACE, the POWER
and ERROR indicators should be on and the READY indica-
tor should be flashing. Make sure that terminal equipment
(TE) is properly terminated as instructed in Setting the
Option Switches on page 4. Plug the TE into one of the Local
Bus connectors at the rear of the unit. A second TE may be
plugged into the remaining Local Bus connector. If more
than two TEs need to be connected to the NT1 ACE, addi-
tional connections can be made in parallel to the S/T bus
using RJ-45 connectors.
.TEs commonly have additional jacks wired in parallel.
These may be used to connect more than two TEs as provid-
ed for by the NT1 ACE. See the TE documentation for fur-
ther information.
After the TE powers up, the ERROR indicator should go out.
There may be some delay between plugging in the TE and
the ERROR indicator going out, depending on the specific
TE in use. If the ERROR indicator fails to go out, see the sec-
tion Troubleshooting on page 11.
As the ERROR indicator extinguishes, the READY indicator
should illuminate. The TE will now be ready to place and
receive calls. There may be a slight delay between the
appearance of the READY indicator and the TE’s ability to
place and receive calls, depending on the specific TE in use.
If the READY indicator fails to illuminate or if you are
unable to place or receive calls, see the section Troubleshoot-
ing on page 11.