Asus AP130-E1 - Manual (Page 56)

Chapter 2: Hardware setup 2-40
To install a floppy disk drive:
1. Position the floppy drive vertically
with the eject button on the left
side (close to the HDDs).
2. Connect the drive signal cable
and power cable.
4. Secure the drive cage with a
screw.
3. Carefully push the drive into the
bay until the drive cage fits the
front edge of the bay.
Eject button
Floppy drive
power cable
Floppy drive
signal cable
Red stripe to match
Pin 1 on the connector