Accell CARDIO PACER - Manual (Page 3)

G B
3
O W N E R ' S M A N U A L
•
C A R D I O P A C E R
NOtE ABOUt SAFEtY
FOR UNItS wItH
ELECtRICAL POwER
Before connecting the equipment to a power
source, make sure that the local voltage
matches that indicated on the type plate:
the equipment operates at either 230 V or
115 V (North American version). NOTE!
The equipment must be connected to a
grounded wall socket. Do not use extension
wires when connecting the equipment to the
power source. Always switch off the power
and unplug the equipment from the electrical
outlet immediately after using!
To reduce the risk of burns, fire, electric
shock or injury to persons:
•
The equipment should never be left
unattended when plugged in. Unplug the
equipment from the outlet when not in use,
before carrying out any maintenance or
repair procedures, and before moving the
unit.
•
Do not operate the equipment under
a blanket or other combustive material.
Excessive heating can occur and cause fire,
electric shock or injury to persons.
•
Do not connect the equipment to a power
source, or operate the equipment if there is
any sort of damage to the power cord or the
unit itself.
•
Do not connect the equipment to a power
source or operate the equipment outdoors or
in damp locations.
•
Keep the power cord away from hot
objects.
•
Do not route the power cord beneath a
carper or place any objects on the cord. Also
make sure that the power cord does not run
underneath the equipment.
•
Do not alter (for example lengthen) the
cord between the transformer and the unit.
NOtE ABOUt
ASSEMBLING tHE
EQUIPMENt
Start by unpacking the equipment. The
detailed assembly instructions can be
found at the back of this guide. Follow the
instructions in given order.
Before assembly, check the contents of the
package. If a part is missing, please contact
your dealer with the model, equipment serial
no. and spare part no. of the missing part.
You’ll find a spare part list at the back of this
guide. The hardware kit contents are marked
with * in the spare parts list. The directions
left, right, front and back are defined as
seen from the exercising position. Keep the
assembly tools, as you may need them e.g.
for adjusting the equipment. Note that two
people are needed for the assembly.
The packaging includes a silicate bag for
absorbing moisture during storage and
transportation. Please dispose of the bag
once you have unpacked the equipment.
Allow at least 100 cm of clearance around
the equipment. We also recommend opening
the package and assembling the product on
a protective base.
SAVE tHIS INStRUCtION MANUAL
ADJUStMENtS
SEAt ADJUStMENt
Set the right height for you; the basic rule is
that the arch of the foot reaches reaches the
the pedal at its lowest point with the leg almost
straight. Adjust the seat height by loosening
the seat locking knob. Hold on to the seat with
one hand and, using your other hand, pull the
locking knob outwards in order to enable free
seat tube movement upwards and downwards.
Once the height is right, let go of the knob and
the seat locks into place. Turn the locking knob
clockwise to tighten.
NOtE!
Always make sure that the locking knob is
properly fastened before starting to exercise!
To adjust horizontal seat position forward and
back, loosen the locking knob under the seat
by turning it clockwise. Adjust the seat to the
desired position and tighten the locking knob
by turning it counter-clockwise.