Sony KE-32TS2E - Manual (Page 23)

23
Menu System
GB
B)
Label a channel using up to five characters.
To do this:
Highlighting the Programme option, press the PROG +/- button
to select the programme number with the channel you wish to
name. When the programme you want to name appears on the
screen, select the Label option and press
. Next press /
/ / to select the letter, then press OK. Finally press
/ / or to select the word “End” on the screen and
press OK to store.
• To correct the letter, select on the screen to go back and press OK.
• For a blank, select on the screen and press OK.
C)
Normally the automatic fine tuning (AFT) will give the best
possible picture, however you can manually fine tune the TV
to obtain a better picture if the picture is distorted.
To do this:
Whilst watching the channel (TV Broadcast) you wish to fine
tune, select the AFT option and press
. Next press
or to adjust the fine tuning between -15 and +15 and
press OK.With the Confirm option highlighted, press OK. Next
press to
select OK and finally press OK to store.
D) Skip any unwanted programme numbers when they are
selected with the PROG +/- buttons.
To do this:
Highlighting the Programme option, press the PROG +/- button
to select the programme number you want to skip. When the
programme you want to skip appears on the screen, select the
Skip
option and press . Next press or to select Yes
and press OK. With the Confirm option highlighted, press OK.
Next press
to select OK and finally press OK to store.
To cancel this function afterwards, select No instead of Yes in the step
above.
E)
View and record scrambled channels when using a decoder
connected to the Scart
3/ either directly or via a
VCR.
This option is only available depending on the country
you have selected in the “Language/Country” menu.
To do this:
Select the Decoder option and press . Next press or to
select On and press OK. With the Confirm option highlighted,
press OK. Next press
to select OK and finally press OK to
store.
To cancel this function afterwards, select Off instead of On in the step
above.
S