Sony VPL-FX50 - Manual (Page 23)

23
(GB)
COLOR SYS (System)
Selects the color system of the input signal.
AUTO: Automatically selects one of the following
signals: NTSC
3.58
, PAL, SECAM, NTSC
4.43
.
PAL-M/N: Automatically selects one of the
following signals: PAL-M/PAL-N, NTSC
3.58
.
Normally, set to AUTO.
If the picture is distorted or colorless, select the color
system according to the input signal.
DDE (Dynamic Detail Enhancer)
Selects the reproduction format of the input video
signals according to the video sources.
FILM: Normally, set to this position. Reproduces
the 2-3 Pull-Down film sources with smooth
picture movement.
When the video signal with a format other than
the 2-3 Pull-Down is input, PROGRESSIVE is
automatically selected.
PROGRESSIVE: Converts an interlace format
video signal to a progressive format.
OFF: Plays back the video signal in an interlace
format without converting.
Input signals and adjustable/setting items
Item Input signal
Video or Component RGB 1)
S video (Y/C)
Video GBR
CONTRAST
BRIGHT
COLOR –
HUE –
SHARP –
RGB – – –
ENHANCER
D. PICTURE –
GAMMA – –
MODE
COLOR
TEMP
COLOR – – –
SYS
DDE –
: Adjustable/can be set
– : Not adjustable/can not be set
The PICTURE CTRL Menu / The INPUT SETTING Menu
(480/60i,
575/50i)
(except for B & W)
(NTSC3.58/
4.43 only)
(480/60i,
575/50i)
The INPUT SETTING Menu
The INPUT SETTING menu is used to adjust the
input signal.
Unadjustable items depending on the input signal are
not displayed in the menu.
Operation
1. Select an item
Use the M or m key to select the item, then press the
, or ENTER key.
2. Adjust an item
• When changing the adjustment level:
To increase the number, press the M or , key.
To decrease the number, press the m or < key.
Press the ENTER key to restore the original screen.
• When changing the setting:
Press the M or m key to change the setting.
Press the ENTER or < key to restore the original
screen.
DOT PHASE
Adjusts the dot phase of the LCD panel and the signal
input from the INPUT A/B (analog signal only)
connector. Adjust the picture further for finer picture
after the picture is adjusted with pressing the APA
key. Adjust the picture to where it looks clearest.
When the video signal is input
When the RGB signal is input
Memory No.
Signal type
Memory No.
Signal type
INPUT SETTING
SHIFT H: 200 V: 30
ASPECT: 16:9
NO.01
VIDEO/60
VIDEO
INPUT SETTING
DOT PHASE: 0
SIZE H: 1056
SHIFT H: 200 V: 30
SCAN CONV: ON
NO.17
800x600
INPUT-A
(480/60i,
575/50i)
.........................................................................................................................................................................................................
1) The RGB signals of a computer. INPUT C is adjustable for the same items as that of the RGB (digital) signals.
(480/60i,
575/50i)
(480/60i,
575/50i)