Sony VPL-FX50 - Manual (Page 26)

26
(GB)
IR RECEIVER
Selects the remote control detectors on the front and
rear of the projector.
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
The INSTALL SETTING
Menu
The INSTALL SETTING menu is used for changing
the settings of the projector.
Operation
1. Select an item
Use the M or m key to select the item, then press the
, or ENTER key.
2. Adjust an item
• When changing the adjustment level:
To increase the number, press the M or , key.
To decrease the number, press the m or < key.
Press the ENTER key to restore the original screen.
• When changing the setting:
Press the M or m key to change the setting.
Press the ENTER or < key to restore the original
screen.
INSTALL SETTING
KEYSTONE MEM: ON
DIGIT KEYSTONE: 0
INSTALLATION: CEILING-FRONT
LENS CONTROL: ON
MENU POSITION: CENTER
MENU COLOR: STANDARD
MENU BACKGRND: STANDARD
INPUT-C FUNC.: ON
LAMP MODE: STANDARD
LAMP TIMER: 234h
INPUT-A
STATUS (on-screen display)
Sets up the on-screen display.
ON: Shows all of the on-screen displays.
OFF: Turns off the on-screen displays except for the
menus, a message when turning off the power,
and warning messages.
For details on the warning messages, see page 33 (GB).
INPUT-B TERM.
Set to PC ANALOG when the RGB signal input to the
INPUT B RGB (DVI) connector is analog, and to PC
DIGITAL when the input RGB signal is digital.
INPUT-A
Selects the computer, component or video GBR (15k
RGB, DTV, HDTV) signal input from the INPUT A
connector.
Note
If the setting is not correct, “Please check INPUT-A
setting.” appears on the screen and the color of the
picture becomes strange or the picture is not
displayed.
AUTO INPUT SEL
When set to ON, the projector detects input signals in
the following order: INPUT-A/INPUT-B/INPUT-C/
VIDEO/S-VIDEO. It indicates the input channel when
the power is turned on or the INPUT key is pressed.
LANGUAGE
Selects the language used in the menu and on-screen
displays.
Available languages are: English, French, German,
Italian, Spanish, Japanese and Chinese.
POWER SAVING
When set to ON, the projector goes into the power
saving mode if no signal is input for 10 minutes.
The SET SETTING Menu / The INSTALL SETTING Menu