Sony ICD-UX523BLK - Manual (Page 133)

ModelName: ICD-UX522/UX522F/UX523/UX523F
PartNumber: 4-293-033-13
1 1 Troubleshooting
Table of
Cont
ents
Inde
x
Message Cause/Remedy
Invalid Operation
 You cannot divide or set a track mark in files in the folder
in the playback-only area (the tab and the tab).
 When a memory card has a bad block on it, the card
cannot be written to. Prepare a new memory card to
replace the current one.
 The file name has reached the maximum number of
characters; you cannot divide the file. Shorten the file name.
 The “Divide All Track Marks” function cannot be used
because there is a track mark within 0.5 seconds from the
dividing position.
 The “Divide All Track Marks” function cannot be used
because there is a track mark within 0.5 seconds from the
beginning of a file or the end of a file.
 The file length is less than 1 second; you cannot divide such
a short file.
 The “Divide Current Position” function cannot be used at a
position within 0.5 seconds from the beginning of a file or
the end of a file.
New File
 The file being recorded has reached the maximum size
limit (2 GB for an LPCM file, and 1 GB for an MP3 file).
The file will be divided automatically and recording will
continue as a new file.
Invalid when Noise Cut is
ON
 When the NOISE CUT switch is set to “ON,” the effect
function does not work. Set the NOISE CUT switch to
“OFF.” ( p. 45).
Change Folder
 If there are no files in the or folder, no folders are
displayed in the display window. A folder containing a file
will be displayed.
Cannot Divide - Exceeds
Max 199 Files in Folder
 When there are already 199 files in the selected folder or
the total number of files stored on the IC recorder exceeds
the maximum, you cannot divide a file. Erase some files
before dividing a file.
Same File Name Exists
 A file of the same file name already exists in the folder, so a
file cannot be created or renamed.
Erased Track Marks too
near Divide Point
 When there is a track mark set within 0.5 seconds from the
dividing position, the track mark is automatically erased.
No operation with
Memory Card
 You cannot set an alarm in a file stored on a memory card.
Switch the memory media of the IC recorder to “Built-In
Memory” ( p. 29, 30).
AVLS *
 The volume of the playback sound exceeds the AVLS-
specified level. Adjust the volume to a moderate level.
System Error
 A system error other than the above has occurred. Remove
the battery and re-insert it.
* : for the European models only