Sony ICD-UX523BLK - Manual (Page 41)

1 1 Recording Files
Table of
Cont
ents
Inde
x
ModelName: ICD-UX522/UX522F/UX523/UX523F
PartNumber: 4-293-033-11

Connect other equipment to the IC recorder when the IC recorder is
in the stop mode.
Connect the audio output connector (stereo mini-plug) of other
equipment to the  jack of the IC recorder using an audio connecting
cable.
“Select Input” appears in the display window.
If “Select Input” is not displayed, set it in the menu ( p . 83 ).

Press  or  to select “Audio IN,” and then press /ENTER.

Press  REC/PAUSE to start recording.
“ ” flashes and the IC recorder enters the recording pause mode.

Start playback on the piece of equipment connected to the IC
recorder.
“ ” appears on the display and synchronized recording starts.
When no sound is detected for more than 2 seconds, “Dividing...” appears and
then “ ” begins to flash. The synchronized recording pauses.
The IC recorder starts recording again as a new file when sound is detected.
To record without using the synchronized recording function
Select “OFF” in step  of “To record using the synchronized recording
function” ( p. 40) , and then proceed with steps  through . When you
press  REC/PAUSE in step , the built-in microphones are automatically cut
off and the sound from the connected piece of equipment is recorded.