Sony SVT11213CXB - Manual (Page 189)

computer’s power state, as it may cause the camera to malfunction.
Care and cleaning of the built-in camera
If the area on and around the built-in camera is soiled, gently wipe it with a soft cloth, such as
a lens cleaning cloth.
Do not rub the area too hard, as it can be easily scratched.
Using Intel(R) Anti-Theft Technology (Intel(R) Anti-Theft Technology supported models)
You can change the Intel(R) Anti-Theft Technology settings in the BIOS setup screen.
Follow these steps to enable Intel(R) Anti-Theft Technology.
1. Press the ASSIST button while your VAIO computer is off.
The VAIO Care (Rescue Mode) screen appears.
2. Select Start BIOS setup.
Enter a password if it has already been set.
The BIOS setup screen appears.
3. Press the or key to select the Advanced tab.
4. Select Intel(R) AT Support System, and then press the Enter key.
5. Press the or key to select Enabled, and then press the Enter key.
6. Press the or key to select the Exit tab, select Exit Setup, and then press the Enter
key.
At the confirmation prompt, press the Enter key.
Charging a USB Device
You can charge a USB device even while your VAIO computer is off, in Hibernate mode, or
Sleep mode by enabling the USB charging settings.
Change the settings while the USB device is disconnected from the USB port that supports USB
charging.
1. Start VAIO Control Center and select Hardware. (See Searching/Starting Apps, Settings,
or Files to start VAIO Control Center.)
2. Enable the USB Charging setting.
3. Connect a USB device to the USB port with the mark printed around it.
If charging does not start even when you connect a USB device to the USB port that
supports USB charging, disconnect and connect the device.