Sony DCR-HC62 User Manual
Page 47
47
U
sin
g
th
e
M
e
n
u
z
Tips
• You can save pictures edited using special
effects on a “Memory Stick Duo” (p. 60) or
record them on another VCR/DVD device, etc.
(p. 56).
Your camcorder will shoot 1 frame of the
picture at a selected interval and keep them
in memory until it has stored several
frames. This function is useful to observe
the movement of clouds or the changes of
daylight. These pictures appear smooth
when played back. Connect your camcorder
to the wall outlet (wall socket) using the
supplied AC Adaptor for this operation.
[a]: Recording
[b]: Interval
1
Touch
t
/
to select a
desired interval time (1 to 120 seconds)
t
.
2
Touch [REC START].
Recording starts and z changes to red.
To interrupt, touch [REC STOP].
To resume, touch [REC START].
To cancel, touch [REC STOP], then [END].
b
Notes
• During Smooth interval recording, your
camcorder may perform the END SEARCH
function to locate the end in current recordings
on the tape after several frames have been
recorded.
• Do not turn off the power or disconnect the
power source while a message is displayed on
the screen.
• The camcorder will shoot several frames for the
first and last shots of the Smooth interval
recording.
• Smooth interval recording is released when
approximately 12 hours have elapsed after
shooting has begun.
• Sounds are not recorded.
• The last few frames may not be recorded if the
battery or tape has run out.
• There may be discrepancies in the interval.
z
Tips
• If you adjust the focus manually, you can record
clear pictures even if the light changes
([FOCUS], p. 39).
• You can silence the recording beep by setting of
[BEEP] (p. 52).
You can record still images on the
“Memory Stick Duo” at a selected interval.
This function is useful to observe the
movement of clouds or the changes in
daylight, etc.
[a]: Recording
[b]: Interval
1
Touch
t a desired interval time (1, 5
or 10 minutes)
t
t [ON] (
)
t
t
.
2
Press PHOTO fully.
stops flashing and the interval still
image recording starts.
To cancel [INT.REC-STL], select [OFF].
The default setting is [ON], allowing you to
view the demonstration about 10 minutes
after you have removed both a cassette and
a “Memory Stick Duo” from your
camcorder, and slide the POWER switch
repeatedly to turn on the CAMERA-TAPE
lamp.
SMTH INT.REC (Smooth interval
tape recording)
INT.REC-STL (Interval photo
recording)
DEMO MODE
Continued
,