Sony DCR-HC62 - Manual (Page 73)

73
Tro
ubl
es
hoo
ting
Image data stored on a “Memory
Stick Duo” cannot be played back.
• Image data cannot be played back if you
have modified file or folder names, or have
edited the data on a computer (In this case,
the file name flashes). This is not a
malfunction (p. 81).
• Pictures recorded on other devices may not
be played back or may not appear in their
actual size (p. 81).
Horizontal lines appear on the
picture. The displayed pictures are
not clear or do not appear.
• Clean the head using the cleaning cassette
(optional) (p. 85).
No sound or only a low sound is
heard.
• Turn up the volume (p. 26).
• Adjust [AUDIO MIX] until the sound is
heard appropriately (p. 49).
• If you are using an S VIDEO plug, make
sure the red and white plugs of the A/V
connecting cable are also connected (p. 32).
The sound breaks off.
• Clean the head using the cleaning cassette
(optional) (p. 85).
“---” is displayed on the screen.
• The tape you are playing was recorded
without setting the date and time.
• A blank section on the tape is being played.
• The data code on a tape with a scratch or
noise cannot be read.
Noises appear and is displayed
on the screen.
• The tape was recorded in a TV color system
other than that of your camcorder (NTSC).
This is not a malfunction (p. 78).
is displayed on the screen.
• The tape you are playing was recorded on
another device with a 4ch microphone
(4CH MIC REC). Your camcorder is not
compatible with 4ch microphone recording.
Date search does not work correctly.
• Be sure to record more than 2 minutes after
the date changed. If one day’s recording is
too short, your camcorder may not
accurately find the point where the
recording date changes.
• There is a blank section in the beginning or
between recorded sections of the tape. This
is not a malfunction.
Pictures from connected devices
cannot be zoomed.
• You cannot zoom pictures from connected
devices on your camcorder (p. 24).
Time code and other information
appear on the display of the
connected device.
• Set [DISP OUTPUT] to [LCD PANEL]
while connected with an A/V connecting
cable (p. 52).
You cannot dub correctly using the
A/V connecting cable.
• The A/V connecting cable is not connected
properly. Make sure that the A/V
connecting cable is connected to the input
jack of another device for dubbing a picture
from your camcorder (p. 56).
New sound added to a recorded tape
is not heard.
• Adjust [AUDIO MIX] until the sound is
heard appropriately (p. 49).
Dubbing/Editing/Connecting to
other devices
Continued ,