Sony XSP-N1BT - Manual (Page 9)

9
GB
To disconnect by One touch
Touch the N-Mark part of the unit with the N-Mark
part of the smartphone again.
Notes
 When making the connection, handle the
smartphone carefully to prevent scratches.
 One touch connection is not possible when the unit is
already connected to another NFC compatible device.
In this case, disconnect the other device, and make
connection with the smartphone again.
When an iPhone/iPod with iOS5 or later installed is
connected to the USB port, the unit is paired and
connected with the iPhone/iPod automatically.
To enable BLUETOOTH Auto Pairing, make sure
[AUTO PAIRING] in BT setup is set to [ON] (page 19).
1
Activate the BLUETOOTH function on the
iPhone/iPod.
2
Connect an iPhone/iPod to the USB port.
Make sure that lights up on the display of the
unit.
Note
BLUETOOTH Auto Pairing is not possible if the unit is
already connected to another BLUETOOTH device. In
this case, disconnect the other device, then connect the
iPhone/iPod again.
Placing a Smartphone on the
Unit
While a smartphone is placed on the unit, the 
(disc eject) button and the display window on the
main unit are not available, although using the App
Remote function allows an Android phone to show
the unit status that is on the device's display
(page 17).
Compatible smartphone dimensions (including a
smartphone case) are;
 Width: 150.7 mm (6 in) maximum
 Height: 59 mm (2 3 / 8 in) to 77 mm (3 1 / 8 in)
 Depth: 12 mm ( 1 / 2 in) maximum
Note
Depending on some smartphones, buttons might be
pressed.
1
Press RELEASE on the main unit to unlock
the cradle clamp.
2
Right-align the smartphone on the unit.
Set the smartphone with the display facing
toward you.
3
Push down on the part marked “LOCK” of
the cradle clamp.
Make sure that the device does not move from
side to side.
Placement of the smartphone
To remove a smartphone
Press RELEASE on the main unit.
Be careful not to allow the device to fall.
About the magnetic charging connector
A Sony Xperia smartphone with a magnetic
charging connector can be charged by placing it on
the unit. (Charging indicator on the smartphone
lights up.) If charging is not possible and the
smartphone is in a case, remove the case, and set
the smartphone on the unit again.
Connecting with an iPhone/iPod
(BLUETOOTH Auto Pairing)
Set within the dotted line to prevent
the device falling to the right side.