Sony NAS-SV20i - Manual (Page 59)

59 GB
A
ddi
tio
n
a
l i
n
fo
rm
ati
o
n
Using the timer
Using the Sleep Timer
You can set the Sleep Timer so that the unit enters
standby mode automatically after a certain period
of time (Sleep Timer function). This function
operates even if the clock is not set.
1
Play the desired sound source.
2
Press SLEEP repeatedly.
Each time you press the button, the time
interval changes as follows.
“SLEEP 15min” t “SLEEP 30min” t
“SLEEP 60min” t “SLEEP 90min” t
“SLEEP Off”( )
( : Factory setting)
The time interval display disappears if you do
not operate the unit for 4 seconds, then the
Sleep Timer is set.
While the unit is processing the selected time
interval, the SLEEP indicator flashes slowly
on the display. It keeps flashing until the unit
enters the standby mode.
You can change the function (sound source,
such as the iPod & iPhone function, the
Home Network function, etc.) before the
Sleep Timer turns the unit off.
After the selected time elapses, the unit enters
standby mode automatically.
To check the remaining time
before the Sleep Timer turns the
unit off
Press SLEEP so that the remaining time before the
Sleep Timer turns the unit off appears on the
display.
Tip
If you set both the Sleep Timer and Play Timer at the same
time, the Sleep Timer takes priority.
Note
If you perform the following operations before the Sleep
Timer turns the unit off, the Sleep Timer resets.
• Disconnect the power cord.
• Update the system of the unit.
• Enter the settings menu and perform “All Reset.”
Using the Play Timer
You can set the Play Timer to start playing an
iPod/iPhone, a music service, or a DAB/DAB+
station (UK model only) at a specified time (Play
Timer function). Make sure you have set the clock.
1
Prepare the sound source.
Select the sound source (iPod/iPhone, Music
Services, or DAB/DAB+), and then press
VOLUME +/– to adjust the volume.
TIMER
M/m/</,/
ENTER
SLEEP
VOLUME +/–
?/1