Sony NAS-SV20i - Manual (Page 68)

68 GB
, Make sure that the router/wireless LAN router/access
point is turned on.
, Confirm the network status. Enter the settings menu
and select “Network Settings” - “Tools” -
“Connection Diagnosis” (page 32). If an error occurs,
an error number appears and “!” appears next to the
error item.
, When the unit is connected via a wireless network,
move the unit and the wireless LAN router/access
point closer to each other and perform the setup
again.
, If your contract with your Internet provider limits
Internet connection to one device at a time, this
device will not be able to access the Internet when
another device is already connected. Consult your
carrier or service provider.
, The bandwidth of your wireless LAN may be too
low. Move the unit and the wireless LAN router/
access point closer to each other, without any
obstacles between them.
, The elapsed time may not be displayed depending on
the content.
, If the clock on the unit has not been set, you cannot
set the Play Timer. Set the clock before setting the
Play Timer (page 23).
, The ending time for the Play Timer cannot be the
same as the starting time.
, A power failure occurred while the timer setting was
in standby mode or the power cord was disconnected.
, The unit may be under the influence of static
electricity or other factors. In this case, restart the
unit. If the unit still works poorly, reset the unit
(page 64).
, If a warning message appears, follow the instructions
given by the message.
, The unit’s internal system may be malfunctioning, or
the unit may be suffering from strong electrical noise
caused by power supply abnormalities due to being
dropped, excessive static electricity, or lightning. In
this case, disconnect the power cord, wait about
40 seconds, and then reconnect it.
Music Services
You cannot connect the unit to a service.
The sound skips.
The elapsed time is not displayed on the
playback display.
Play Timer
“Date&Time Error” appears.
“Time Error” appears.
Play Timer setting does not function when the
starting time is reached.
Others
The unit works poorly.
The unit does not respond to any operations.
The unit does not work correctly.