Sony MDR-RF960RK User Manual

Page 10

Advertising
background image

10

GB

5

Turn up the volume to a moderate
level with the VOL control.

A

MDR-RF960RK

Press the TUNE button briefly for
automatic tuning of the headphones.
If you do not receive a clear audio
signal, press it again.

B

MDR-RF920RK

Tune the headphones into the frequency
of the transmitter with the TUNE
control until you can hear the audio
signal loud and clear.

Follow steps 3 and 5 above until the
receiving performance becomes better.

Bad reception conditions

If you use the unit near a cordless telephone, it may
cause radio interference. If poor reception occurs, try
another channel using the CHANNEL selector.

Sending RF signals from the Transmitter
The transmitter starts sending the RF signals
automatically, when it detects audio signals from
the equipment connected.
If it does not detect an audio signal for more than
approximately 10 minutes, the transmitter will
stop sending RF signals, and the power indicator
turns off.
When the transmitter receives an audio signal
again, it starts sending the RF signals, and the
power indicator will light in red again.
If the audio signal is very weak, the transmitter
does not send RF signals. If the transmitter is
connected to a headphone jack, make sure the
volume of the equipment connected is set to 5 – 6
or higher.
You may not hear the beginning of the sound
from the headphones until the transmitter starts
sending the RF signals after detecting an audio
signal.

Note
If the transmitter is connected to the headphones jack of
the source equipment, set the volume of that equipment
as high as possible without distorting the audio signal.

The headphones automatically turn
off when they are taken off
– Auto power on/off function

Do not pull up the self-adjusting band when not
in use, as this will consume the battery power.

Notes
• If hiss is hear, move closer to the transmitter.
• You may hear some noise when you disconnect the

AC power adaptor from the transmitter before taking
off the headphones.

After listening to a program

Take the headphones off and rest them away on the
transmitter, and recharge them.

Note
Do not hang the headphones by the self adjusting band,
otherwise, the self adjusting band will be pulled up and
the headphones will be switched on.

VOL control

VOL control

TUNE

TUNE

TUNE
button

TUNE
control

Advertising
This manual is related to the following products: