Sony MDS-PC3 - Manual (Page 15)

15 GB
2
Select “Search for the best driver for your device.
(Recommended).” (For the computer system with the CMT-C7NT
connected to it, refer to the operating instructions for that system
stereo component.)
Load the Windows Me CD-ROM into the CD-ROM drive of the
computer if the wizard requests it, and then install the drivers.
Installation procedure will be repeated for each of the following
devices.
• USB audio device
• USB composite device
• Generic USB hub
Installing the USB drivers (Windows XP)
1
Quit any applications that are active.
2
Connect the system stereo component to the computer directly or
via the PC connecting adaptor, and then start up the computer.
Installation of the drivers starts automatically, and will be
terminated after completing installation.
If “Found New Hardware Wizard” should appear, go to step 3.
3
Select “Install the software automatically [Recommended]” after
confirming that the name of the device for which the drivers are to
be installed is “SONY LINK KIT.”
Verifying the status of the installed devices (Windows 2000/
Windows Me/Windows XP)
Be sure to check the status of the installed devices after you have
installed thier drivers.
1
Open the Control Panel.
In the Start menu, point to “Settings” and click “Control Panel”.
(For Windows XP) In the Start menu, click “Control Panel,” and
then click “Switch to Classic View” on the left pane of the window.
(continued)