Sony MDS-PC3 - Manual (Page 29)

29 GB
Problem Cause/countermeasure
The system sounds (warning
alarm/mail arrival notice) are not
heard. t The system sounds have been specified not to
sound during M-crew startup, or the setting
may have changed to OFF when M-crew was
abnormally ended. To restore the sounds,
restart M-crew and then quit the program
normally. Or double-click the backup file
(reg0.reg to reg3.reg) in the M-crew folder
and follow the instructions to set up the
program again (except for Windows XP).
The installed devices are not set
properly. t Refer to the “Readme.txt” file in the Start
menu. The “Readme.txt” file is in the folder
which the M-crew software is installed in.
No sound comes out of the built-
in or external speakers of the
computer. The USB audio device is preferred on the
computer that has a USB connection to a system
stereo component.
t Select the standard audio device (usually the
built-in sound card of the computer) for the
preferred device in the “Sounds and
Multimedia Properties” dialog box (page 17).
No sound from the system stereo
component comes out of the
built-in or external speakers of
the computer. t Connect the analog output terminal on the
system stereo component and the line-in
terminal on the computer with an audio cable,
and then uncheck the “Mute” check box under
the “Line In Balance:” section in Volume
Control.
The message “Could not connect
to the CDDB.” appears. t Check that you are successfully connected to
the Internet.
t If you have access to the Internet through a
proxy server, check the proxy settings in the
“Option” dialog box.