Acumen CAT21 - Manual (Page 11)

Troubleshooting
10
The Acumen CAT21 is manufactured using automotive specification
parts, including a waterproof connector, and is fully encapsulated to
provide protection against water and vibration. The system relies on
various signals to make it function correctly and any one of these
signals may cause false reactions.
FFa allsse e a alla arrm mss;; E En ntte err d diia ag gn no ossttiic c m mo od de e tto o sse ee e w wh hyy tth he e a alla arrm m h ha ass
ttrriig gg ge erre ed d..
2 beeps. Blown fuse - Replace. If it blows again contact the installing
dealer.
3 beeps. The unit has detected an ‘hotwire’ signal.
4 beeps. The movement or nudge sensor has reacted. Enter
Convenience Mode (Section 2) to remove this function until the
problem is sorted.
5 beeps. Anti tamper switch - ensure it is mounted correctly.
S Syysstte em m c ca an nn no ott b be e a arrm me ed d o orr d diissa arrm me ed d b byy tth he e rre em mo otte e ttrra an nssm miitttte err
1. Check the ignition switch is in the off position
2. Check the system fuse
3. Check you are within normal operating range of the motorcycle
(10 metres max)
4. Check the condition of the transmitter battery
5. The transmitter can be affected by other radio sources. This
problem can usually be overcome by placing the transmitter as
close as possible to the alarm system. Alternatively, you can move
the motorcycle a distance which will reduce the affect of the
interference. In this event you can disarm the system by using the
PIN.