System overview – Acumen CAT21 User Manual
Page 3
System Overview
2
The Acumen CAT21 consists of the following main
components;
•
Installed CAT21 main unit
•
2 x remote transmitters
•
Installed protecting switch
•
Installed system fuse and spare fuse
•
LED system indicator
Be sure that you know:
11..
W
Wh
he
erre
e tth
he
e ssyysstte
em
m ffu
usse
e iiss,, a
an
nd
d w
wh
he
erre
e tth
he
e ssp
pa
arre
e ffu
usse
e iiss llo
oc
ca
atte
ed
d.. IIff
tth
he
e ffu
usse
e ffa
aiillss,, tth
he
e ssyysstte
em
m w
wiillll n
no
ott a
allllo
ow
w tth
he
e m
mo
otto
orrc
cyyc
clle
e tto
o sstta
arrtt..
22..
S
Se
ett yyo
ou
urr P
PIIN
N o
ovve
errrriid
de
e.. T
Th
hiiss w
wiillll e
en
na
ab
blle
e yyo
ou
u tto
o d
diissa
arrm
m tth
he
e ssyysstte
em
m
a
an
nd
d ssttiillll sstta
arrtt yyo
ou
urr m
mo
otto
orrc
cyyc
clle
e iiff tth
he
e rre
em
mo
otte
e ttrra
an
nssm
miitttte
err iiss llo
osstt o
orr
d
do
oe
ess n
no
ott ffu
un
nc
cttiio
on
n ((sse
ee
e S
Se
ec
cttiio
on
n 1166))..
The CAT21 will monitor;
1. The motorcycle battery and associated motorcycle wiring. If the
battery is disconnected or the ignition is switched on the alarm will
trigger. The CAT21 also monitors the state of the motorcycle battery
for ‘sleep’ purposes.
2. The ignition circuit. If the ignition is switched on while the CAT21 is
protecting the system it will trigger an alarm. Also, the CAT21 Uses
the ignition to enter diagnostic and service mode.
3. Nudge and movement, with a liquid filled, state-of-the-art sensor.
Nudge will result in beeps, movement will result in a full alarm.
4. An anti-tamper switch will cause the alarm to trigger if an attempt
is made to gain unauthorised access to the CAT21 system.
The CAT21 also;
1. Has a ‘fully armed’ mode (see section 1)
2. Has a ‘Convenience’ mode (see section 2)
3. Has a service/valet mode (see section 3)
4. Has a diagnostic mode (see section 4)
5. Has 14 different siren tones (see section 5)
6. Can have the audible warning of arming/disarming turned on or off.
(see section 6)
7. Can activate all four indicators in a Hazard warning mode
(see section 7)
8. Can be programmed to have the nudge sensing removed
(see section 8)
9. Can be programmed to act as an indicator or warning system when
riding the motorcycle (see section 9)
10. Will tell you if it senses excess voltage when the engine is running
(see section 10)
11. Will tell you if the remote transmitter batteries are becoming
discharged (see section 11)
12. Has a useful torch in the remote transmitter (see section 12)
13. Has an ignition key conversion feature in the remote transmitter
(see section 13)
14. Will tell you if the alarm has triggered in your absence
(see section 14)
15. Has a user-selectable PIN override number (see section 16)