Acumen CAT21 - Manual (Page 4)

The Remote Transmitter
3
Ignition key
The system is supplied with 2 transmitter/Ignition keys, if a new
transmitter is supplied, a new key can be attached as shown in the
diagram opposite.
When all three buttons are pressed at once and held
for 5 seconds
W Wiitth h iig gn niittiio on n o offff - Silent arm/disarm is toggled (14 flashes on/7 off)
W Wiitth h ssyysstte em m a arrm me ed d o orr d diissa arrm me ed d - on/off
W Wiitth h iig gn niittiio on n o on n,, ssyysstte em m d diissa arrm me ed d - Nudge sensor toggled on/off
(6 flashes on/3 off)
W Wiitth h iig gn niittiio on n o offff,, ssyysstte em m iin n sse errvviic ce e m mo od de e - Indicators on warning
function is toggled on/off (5 flashes on/10 off)
Standard Settings of the system
When the system arms, immobilisation and hot wire (ignition circuit
becomes live) functions only will be enabled.
The system will arm automatically 50 seconds after the ignition is
switched off. (this time cannot be altered)
You can manually arm the system by pressing the lock button. (You will
get 2 beeps and 2 flashes of the indicators) (see section 6)
To disarm the system, press the lock button. (You will get 1 beep and 1
flash of the indicators) (see section 6)
The system will arm with an audible warning of arming.
T Th hiiss b bu utttto on n w wiillll;;
• Deactivate/activate tilt
and vibration,
• Select siren tone,
• Select number of
digits in PIN
T Th hiiss b bu utttto on n w wiillll;;
• Arm & disarm the system,
• Allow you to enter Diagnostic
and Service Modes.
T Th hiiss b bu utttto on n w wiillll;;
• Activate the torch
T Th hiiss b bu utttto on n w wiillll;;
• Allow the ignition key
to swivel out
These screws (x2)
attach the ignition
key to the transmitter
Undo these screws (x3)
to remove cover and
replace batteries
Replacement battery type CR2016