Alpine CDA-117 - Manual (Page 49)

47
-EN
• The subscribed program is being updated. During update, audio will
be muted until update is completed.
– Wait until the update is completed. After completion, follow the
indication “SUB Updated Press Any Key” to press any key on the
unit to continue, the unit re-tune to previous channel.
• The Receiver is updating the SIRIUS channel line up. During update
audio will be muted until update is completed.
– Wait until the channel update is completed. After completion, the
unit automatically re-tune to previous channel.
• Database error or decoder error.
– You can solve the problem by switching the source.
• Communication error or boot error, etc.
– You can solve the problem by reconnecting the USB Memory/
Portable audio player or changing source.
• The Portable audio player is not verified.
– You can solve the problem by reconnecting the Portable audio
player.
• Abnormal current is run to the USB connector device.
– You can solve the problem by switching the source.
• A USB device/Portable audio player that is not supported by the unit
is connected.
– Connect a USB device/Portable audio player that is supported by
the unit.
• A USB Memory/Portable audio player is not connected.
– Make sure the USB Memory device/Portable audio player is
correctly connected and the cable is not excessively bent.
• No song (file) is stored in the USB Memory/Portable audio player.
– Connect the USB Memory device/Portable audio player after
storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
– Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
– You can only play back non-copy-protected files.
• The iPhone/iPod is not connected.
– Make sure the iPhone/iPod is correctly connected (refer to
“Connections” on page 52).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
– Download songs to the iPhone/iPod and connect to this unit.
• Database error or decoder error.
– You can solve the problem by sw tching the source.
• Communication error or boot error, etc.
– You can solve the problem by reconnecting the iPhone/iPod or
changing source.
• The iPhone/iPod is not verified.
– You can solve the problem by reconnecting the iPhone/iPod.
• Abnormal current is run to the USB connector device.
– You can solve the problem by sw tching the source.
• A USB device that is not supported by the un t is connected.
– Connect a USB device that is supported by the unit.
Indication for USB Memory/Portable
audio player
(SIRIUS mode)
(SIRIUS mode)
Indication for iPhone/iPod Mode