Alpine CDA-117 - Manual (Page 9)

7
-EN
Accessory List
• Head unit ..................................................................................1
• Power cable...............................................................................1
• USB Cable..................................................................................1
• Interface cable for iPod............................................................1
• Mounting sleeve.......................................................................1
• Carrying case ............................................................................1
• Bracket key ...............................................................................2
• Screw (M5 × 8) ..........................................................................4
• Remote Control ........................................................................1
• Battery (AAA size).....................................................................2
• Owner’s Manual..................................................................1 set
Turning Power On and Off
1
Press SOURCE  to turn on the unit.
Note
• The unit can be turned on by pressing any other button.
1
Press and hold SOURCE  for at least 2 seconds to turn
off the unit.
Note
• The first time power is turned on, the volume will start from level 12.
Source Selection
1
Press SOURCE  to change the source.
TUNER  XM/SIRIUS *1  DISC  USB *2 /USB iPod *3  AUX+ *4 
Bluetooth Audio *5  CHANGER *6  TUNER
*1 Only when XM Radio or SIRIUS Radio is connected.
*2 Displayed only when no iPhone/iPod is connected.
*3 Displayed only when the iPhone/iPod is connected.
*4 Displayed only when the AUX+ SETUP is set to ON, refer to
“Setting the AUX+ Setup Mode” on page 22.
*5 Displayed only when Bluetooth IN is set to ADAPTER, refer to
“Setting the BLUETOOTH Connection” on page 21.
*6 Only when the CD changer is connected.
Detaching and Attaching the Front Panel
1
Turn off the unit power.
2
Press  (OPEN) to open the front panel (figure 1).
To close the front panel, press the left side until it locks as shown
in the figure 2.
3
Grasp the front panel firmly, slide to the left , and then
pull  to remove.
Notes
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it may
result in malfunction.
• Do not leave the front panel open, or drive the car with the panel open
as it may result in an accident or malfunction.
1
Insert the right side of the front panel into the main unit.
Align the groove on the front panel with the projections
on the main unit.
2
Push the left side of the front panel until it locks firmly into
the main unit.
Notes
• Before attaching the front panel, make sure that there is no dirt or dust
on the connector terminals and no foreign object between the front
panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.
Getting Started
MUTE
SETUP
(OPEN)
/ESC
Rotary encoder/ENTER/ 
SOURCE/ 
Detaching
Attaching
figure 1 figure 2