Agilent Technologies Agilent 4396B - Manual (Page 13)

Contents
1. Installation and Setup Guide
Incoming Inspection . . . . . . . . . . . . . . . . . 1-1
Replacing Fuse . . . . . . . . . . . . . . . . . . 1-3
Fuse Selection . . . . . . . . . . . . . . . . . . . 1-3
P ower Requirements . . . . . . . . . . . . . . . . . 1-4
P ower Cable . . . . . . . . . . . . . . . . . . . . 1-4
Operation Environment . . . . . . . . . . . . . . . . 1-6
Providing clearance to dissipate heat at installation site . 1-6
Instruction for Cleaning . . . . . . . . . . . . . . . . 1-6
Rack/Handle Installation . . . . . . . . . . . . . . . 1-7
Option 1CN Handle Kit . . . . . . . . . . . . . . . 1-7
Installing the Handle . . . . . . . . . . . . . . . 1-7
Option 1CM Rack Mount Kit . . . . . . . . . . . . . 1-8
Mounting the Rack . . . . . . . . . . . . . . . . 1-8
Option 1CP Rack Mount & Handle Kit . . . . . . . . 1-8
Mounting the Handle and Rack . . . . . . . . . . 1-8
Front View . . . . . . . . . . . . . . . . . . . 1-9
Rear View . . . . . . . . . . . . . . . . . . . . 1-11
Connecting a T est Set for Network Analyzer Mode . . . 1-12
Connecting an A ctive Probe . . . . . . . . . . . . . . 1-14
F or Spectrum Analyzer Mode . . . . . . . . . . . . 1-14
F or Network Analyzer Mode . . . . . . . . . . . . 1-15
Connecting a Keyboard . . . . . . . . . . . . . . . . 1-17
Setting Up a 75 Measurement F or Spectrum Analyzer
Mode . . . . . . . . . . . . . . . . . . . . . . . 1-18
2. Spectrum Analyzer T our
Before Y ou Leave On The T our . . . . . . . . . . . . 2-1
Overview . . . . . . . . . . . . . . . . . . . . . 2-1
Required Equipment . . . . . . . . . . . . . . . . 2-2
Step 1: Preparing for a Measurement . . . . . . . . . 2-3
Turning ON the analyzer . . . . . . . . . . . . . . 2-3
Connecting the T est Signal Source . . . . . . . . . . 2-3
Step 2: Setting Up the Analyzer . . . . . . . . . . . . 2-4
Setting the A ctive Channel . . . . . . . . . . . . . 2-4
Setting the Analyzer Type . . . . . . . . . . . . . . 2-5
Selecting the Input . . . . . . . . . . . . . . . . . 2-6
Setting the Frequency Range . . . . . . . . . . . . 2-6
Step 3: Making a Measurement . . . . . . . . . . . . 2-8
Reading the P eak Level Using the Marker . . . . . . 2-8
Setting the Resolution Bandwidth to See Low Level
Signals . . . . . . . . . . . . . . . . . . . . . 2-9
Contents-1