Sony LF-PK1 - Manual (Page 20)

Setu
p an
d Co
nn
ecti
o
n
s
20
7
Read the “Dynamic DNS Terms-of-Use
Agreement” included in the box and then
click [Agree].
When you click [Agree], the information
required for the dynamic DNS is saved to the
base station.
8
Follow the on-screen instructions to wait
until the NETAV LED stops blinking
(umber) and click [Next] when the NETAV
LED turns off.
z Tips
• The NETAV LED continues to blink for about
one minute before turning off.
• If the NETAV LED turns on umber, check that
the router and modem are turned on and the
LAN cable is connected properly.
• When the NETAV LED turns green, another
device is connected by NetAV. Wait until the
LED turns umber to perform this step.
• NetAV cannot be used via a proxy server.
9
Click [Check].
The setup is complete if [Success] appears in
the [NetAV Check] page.
If the test page does not appear, check the
network connection.
10
Click [Exit Setup].
Restart the base station.
Close the browser.
Read the instructions on the NetAV Check page
and configure the necessary settings.
The base station needs to be set up to use the
NetAV function away from home. There are two
setup types: [Easy Setup] and [Advanced Setup].
[Easy Setup] requires the router to be UPnP
compatible and the UPnP function of the router to
be enabled. Refer to the operating instructions for
your router and confirm the settings.
If your router is not UPnP compatible, you prefer
not to use the UPnP function of the router, or if
you use the UPnP function but the setup is
unsuccessful, port forwarding needs to be set on
the router.
z
Tips
• Setting port forwarding on the router requires a
static IP address to be set in the [Internet
Connection] frame of the [Advanced Setup] page for
the base station. For details, refer to the instruction
If NetAV Check is incomplete