Sony LF-PK1 - Manual (Page 5)

Identifying Parts and Controls (Base Station)
5
Identifying Parts and Controls
(Base Station)
1 WIRELESS LED
Indicates the wireless function status.
Blue: Connected with the LocationFree device on the 5 GHz
channel.
Green: Connected with the LocationFree device on the 2.4 GHz
channel.
Turns blue or green momentarily, then turns off for 3 seconds:
Wireless is enabled, but wireless communication with a
LocationFree device is not taking place.
2 NETWORK LED
Indicates the connection status to an external network, such as the
Internet.
Green slow blinking: Attempting to connect.
Green: Connected to the network. The LED blinks quickly when
data is transmitted.
Off: Not connected.
3 NETAV LED
Indicates the connection status with the LocationFree device.
Green fast blinking: NetAV authentication has failed.
Green slow blinking: Attempting to connect with NetAV.
Green: Connected with NetAV.
Umber blinking: Updating dynamic DNS.
Umber: Dynamic DNS failure.
Off: Not connected.
Red: The base station is being initialized.
4 SETUP MODE LED ( 1 page 12)
Umber: The base station is in Setup mode.
Umber blinking: Easy registration is possible.
5 POWER LED ( 1 page 13)
Green: The power is on.
Red blinking: A malfunction has occurred.
6 POWER button ( 1 page 13)
Turns the base station power on and off.
7 LAN port
Connect a LAN cable.
8 BASE STATION RESET button ( 1 page 48)
Initializes all settings on the base station to the factory defaults.
9 SETUP MODE button ( 1 page 12)
Press to register LocationFree devices, or to make base station
settings.
0 IN 2 (AUDIO/VIDEO) terminal ( 1 page 9)
Connect audio and video cables.
qa DC IN jack ( 1 page 13)
Connect the AC power adapter (supplied).
qs VHF/UHF jack ( 1 page 7)
Connect an antenna cable.
qd IN 1 (S-VIDEO/AUDIO/VIDEO) terminal ( 1 page 9)
Connect audio cables and either a video or S-video cable.
qf IR BLASTER port ( 1 page 10)
Connect the IR Blaster (supplied).
Front
1
2
3
5
4
6
Rear
qa
0
8
9
7
qf
qd
qs