Messages, Help guide – Sony DSC-H400 User Manual
Page 233
Digital Still Camera
DSC-H400
Messages
The battery level is low. Charge the battery pack immediately. Depending on the conditions of use or the type of
battery pack, the indicator may flash even though there are still 5 minutes to 10 minutes of remaining battery time left.
System error. Turn on the device again.
Turn the power off and then on again.
Internal memory error
Turn the power off and then on again.
Reinsert the memory card that you were using.
The inserted memory card cannot be used in the camera.
The terminal section of the memory card is dirty.
The memory card is damaged.
Incompatible type of memory card.
The inserted memory card cannot be used in the camera.
Buffer overflow. Writing to the media was not completed in time.
If you use a memory card that has been recorded and erased repeatedly, or that was formatted on a different camera,
the data writing speed may be too slow. First back up any data on the card to a computer, and then reformat the card
before using it.
The writing speed of the memory card you are using is not sufficient for movie recordings. Use one of the memory
cards listed below.
Memory Stick PRO Duo (Mark2) media, Memory Stick PRO-HG Duo media, Memory Stick media. Memory Stick XC-HG
Duo media or Memory Stick Micro (Mark2) media.
SD memory card, SDHC memory card, SDXC memory card, microSD memory card or microSDHC memory card (Class 4 or
faster).
Cannot recognize the internal memory. Format and use again.
Cannot recognize this memory card. Format and use again.
Format the media again.
The memory card is locked. Check the tab.
You are using the memory card with the write-protect switch, and the switch is set to the LOCK position. Set the
Troubleshooting
229