Sony SDM-N80 - Manual (Page 22)

22
D:\SDM\n80\N80GB\001009\3868361251\386836125SDMN50AEP\02GB-
SDMN50AEP\01GB02BAS-AEP.fm masterpage:Left
SDM-N80
4-082-671-12(1)
Troubleshooting
Before contacting technical support, refer to this section.
On-screen messages
If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see “Trouble symptoms and remedies” on page 23.
If OUT OF SCAN RANGE appears on the screen
This indicates that the input signal is not supported by the
monitor’s specifications. Check the following items.
If “xxx.x kHz / xx Hz” is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor’s specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
If “RESOLUTION > UXGA” is displayed
This indicates that the resolution is not supported by the
monitor’s specifications.
If NO INPUT SIGNAL appears on the screen
This indicates that no signal is being input from the currently
selected connector.
INPUT:
This indicates the currently selected connector (INPUT: 1 or
INPUT: 2).
If “GO TO POWER SAVE” is displayed
When the POWER SAVE menu is set to ON, the monitor
enters the power saving mode after about 4 seconds from the
time the message is displayed.
If “USB CONNECTED” is displayed
This indicates that a computer whose power is on is connected
to the USB upstream connector on the monitor. For that
reason, the monitor will not enter the power saving mode even
if the POWER SAVE menu is set to ON.
If PLEASE CHANGE TO SXGA appears on the
screen
This indicates that the resolution of the input signal exceeds
1280
×
1024 (SXGA). Set your computer to output a signal
1280
×
1024.
If CABLE DISCONNECTED appears on the screen
This indicates that the video signal cable has been
disconnected from the currently selected connector.
INPUT:
This indicates the currently selected connector (INPUT: 1 or
INPUT: 2).
If “GO TO POWER SAVE” is displayed
When the POWER SAVE menu is set to ON, the monitor
enters the power saving mode after about 4 seconds from the
time the message is displayed.
If “USB CONNECTED” is displayed
This indicates that a computer whose power is on is connected
to the USB upstream connector on the monitor. For that
reason, the monitor will not enter the power saving mode even
if the POWER SAVE menu is set to ON.
OUT OF SCAN RANGE
x x x . x k H z / x x H z
I NFORMA T I ON
NO I NPUT S I GNA L
I NPUT : 1
GO TO POWER SAVE
I NFORMA T I ON
RESOL UT I ON > SXGA
P L EASE CHANGE TO SX A G
I NFORMA T I ON
CAB L E D I SCONNECT ED
I NPUT : 1
GO TO POWER SAVE
I NFORMA T I ON
01GB01COV-AEP.book Page 22 Monday, July 16, 2001 2:22 PM