Sony DCR-HC32 - Manual (Page 11)

11
Getting Started
DCR-HC32/HC42 2-584-906-11(1)
6
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack.
Disconnect the AC Adaptor from the
DC IN jack holding both the Handycam
Station and the DC plug.
To charge the battery pack using only
the AC Adaptor
Turn off the power, then connect the
AC Adaptor to the DC IN jack on your
camcorder.
•
You can operate your camcorder
connected to a power source such as a
wall outlet as shown in the illustration.
The battery pack will not lose its charge
in this case.
DC IN jack
With the  mark facing
down
AC Adaptor
To the wall outlet
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
To remove the battery pack
Turn off the power, then slide the battery
pack in the direction of the arrow while
pressing the PUSH button.
PUSH button POWER switch
When storing the battery pack
Fully discharge the battery before storing it
for an extended period (p. 110).
Continued 