Sony DCR-HC32 - Manual (Page 51)

51
Using the Menu
DCR-HC32/HC42 2-584-906-11(1)
To interrupt, touch [REC STOP] in step .
To resume, touch [REC START].
To cancel, touch [REC STOP], then [END].
• When your camcorder has shot several frames,
it records them on the tape, after performing
the END SEARCH function depending on the
interval length.
• Do not turn off the power or disconnect the
power source while a message is displayed on
the screen.
• The camcorder will shoot several frames for
the first and last shots of the Smooth interval
recording.
• Smooth interval recording is released when
approximately 12 hours have elapsed after
shooting has begun.
• Sounds are not recorded.
• The last few frames may not be recorded if the
battery or tape has run out.
• There may be discrepancies in the interval.
• If you adjust the focus manually, you can
record clear pictures even if the light changes
([FOCUS], p. 42).
• You can silence the beeps during recording.
INT.REC-STL
(Interval photo recording)
You can record still images on the
“Memory Stick Duo” at a selected interval.
This function is useful to observe the
movement of clouds or the changes in
daylight, etc.
[a]: Recording
[b]: Interval
 Touch  a desired interval time (1, 5
or 10 minutes)   [ON]  
.
 Press PHOTO fully.
stops flashing and the interval still
image recording starts.
To cancel [INT.REC-STL], select [OFF]
in step
 .
DEMO MODE
The default setting is [ON], allowing you
to view the demonstration in about 10
minutes, after you have removed both a
cassette and a “Memory Stick Duo” from
your camcorder, and slide the POWER
switch down to turn on the CAMERA-
TAPE lamp.
• The demonstration will be suspended in
situations such as those described below.
– When you touch the screen during the
demonstration. (The demonstration starts
again in about 10 minutes.)
– When a cassette or a “Memory Stick Duo” is
inserted.
– When the POWER switch is set to other than
CAMERA-TAPE.
– When NIGHTSHOT PLUS switch is set to
ON.
PRINT
See page 67.