Sony MZ-RH910 - Manual (Page 76)

76
The recorder does
not work or works
poorly. • The lid is not firmly closed.
, Close the lid until it clicks. Then slide OPEN to open the lid.
• Moisture has condensed inside the recorder (for example, when the
recorder has been brought in from a cold place to a warm place).
, Take the disc out and leave the recorder in a warm place for several
hours until the moisture evaporates.
• The AC power adaptor is not firmly connected.
, Connect the AC power adaptor firmly to the DC IN 3V jack on the
recorder.
• The rechargeable battery or dry battery is weak (“LOW BATTERY”
flashes or nothing appears).
, Charge the rechargeable battery, replace the dry battery with a new
one, or use the supplied AC power adaptor.
• The disc is damaged or does not contain proper recording or editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• There is a built-in malfunction in the system.
• While operating, the recorder received a mechanical shock, too much
static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Disconnect all the power sources and the dedicated USB cable.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
File names or folder
names displayed by
the File list function
are different from
those saved on the
computer. • File names and folder names that exceed the maximum display length
supported by the recorder are shortened.
The file names or
folder names are not
correctly displayed
by the File list
function. • The names contain characters that are not supported by the recorder.
The operation mode
of the blank 60/74/
80-minute standard
disc differs from the
mode following
formatting or the
mode selected in the
SonicStage software. • When using a blank 60/74/80-minute standard disc in the recorder, the
operation mode set in the “Disc Mode” menu is applied.
, Use the “Disc Mode” menu to change the operation mode as
desired.
Symptom Cause/Remedy