Antex electronic XM-100 - Manual (Page 17)

XM-100 Commercial Satellite Audio Receiver 17
used for forced tuning (explained below) is on the left side of
the display.
The line maximum output level may is adjusted using the
up/down buttons.
Front Lock
When Setup – Front Lock is displayed, pressing the Mode
button brings up the following menu:
Front Lock?
Locked
The buttons on the front of the XM-100 unit may be locked or
unlocked using this feature. Locking the unit may be useful if a
store manager or parent wishes to ensure the desired channel
is not altered. When locked and a button on the unit is
pressed, the work LOCKED briefly appears and no change is
made to the current channel or power state.
Note that the remote control will still continue to operate
normally, and therefore it must be secured for this lockout to
be useful. The remote is also required to unlock the front panel
– press the setup key on the remote to enter the menus
allowing the front to be set to unlocked.
Time Zone
When Setup – Time Zone is displayed, pressing the Mode
button brings up the following menu:
Timezone?
Pacific
Use the up/down keys to set the proper time zone and press
the Mode key to ascend back up one menu level.
XM’s satellite transmission broadcasts time in GMT. For local
forced tune events (explained later) to work properly, the time
zone in which the XM-100 resides in must be set so that local
time may be derived from the broadcast GMT signal.