Antex electronic XM-100 - Manual (Page 6)

XM-100 Commercial Satellite Audio Receiver 6
Parts List
Before installing your XM-100, make sure you have all the
parts listed below:
XM-100 unit
Antenna
Remote control
Power Adapter
RCA audio cable
Connections
House the XM-100 unit in a component rack or other suitable
location that provides adequate ventilation. The maximum
ambient temperature should never exceed 120 degrees
Fahrenheit. The unit’s front user interface and various
connectors on the back of the unit are shown here:
Connect the XM-100 as follows:
1. Audio output – audio connection may be made to either
the RCA outputs or the 3.5mm output jack. These two
output connectors are internally wired in parallel, and it is
generally not recommended that both outputs be used
simultaneously unless it is known that both outputs drive a
high impedance load. The maximum level is 2VRMS.
RF IN
Connect to
antenna
RCA line level
audio out
3.5 mm line
level audio
out
RS232
control
port
DC power in