Sony DCR-PC350 - Manual (Page 16)

Getting started 16
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (F series) to
your camcorder.
b Note
• You cannot use batteries other than the
“InfoLITHIUM” battery pack (F series) (p. 130).
• Do not short-circuit the DC plug of the AC Adaptor
or battery terminals with any metallic objects. This
may cause a malfunction.
• Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
1
Attach the charged battery pack to the
camcorder.
1 Slide the BATT (battery release)
lever in the direction of 1 and push it
down in the direction of 2.
Remove the battery terminal cover when
it lifts up in the direction of 3.
2 Attach the battery pack with its terminal
side facing your camcorder as shown in
the following illustration and press down
the battery pack until it clicks.
2
With the v mark on the DC plug facing
up, connect the AC Adaptor to the DC
IN jack on the Handycam Station.
3
Connect the power cord to the AC
Adaptor.
4
Connect the power cord to the wall
outlet.
To the wall outlet
DC plug
Power cord
AC Adaptor
DC IN jack
Handycam Station
BATT (battery release) lever
v
mark
DC IN jack