Sony HT-DDW870 - Manual (Page 28)

masterpage:Left
lename[E:\SEM_Janet\Revision_DDW870\J9040000_2549734121DDW870UCA\2549734121\
GB04BSC_HT-DDW870-UCA.fm]
28 GB
model name1[HT-DDW870]
[2-549-734-12(1)]
A SW: Lights up when the audio signal is output
from the SUB WOOFER jack.
B LFE: Lights up when the disc being played
back contains the LFE (Low Frequency
Effect) channel and the LFE channel signal is
actually being reproduced.
C SP A/SP B: Lights up in accordance with the
speaker system being used (A or B). Turns off
when speaker output is turned off or when
headphones are connected.
D ; DIGITAL EX: “; DIGITAL” lights up
when Dolby Digital signals are input.
“; DIGITAL EX” lights up when Dolby
Digital EX signals are input.
Note
When playing a Dolby Digital format disc, be
sure that you have made digital connections and
that INPUT MODE is not set to “ANALOG”
(page 35).
E ; PRO LOGIC IIx: “; PRO LOGIC”
lights up when the receiver applies Pro Logic
processing to 2 channel signals in order to
output the center and surround channel
signals. “; PRO LOGIC II” lights up when
the Pro Logic II Movie/Music/Game decoder
is activated. “; PRO LOGIC IIx” lights up
when the Pro Logic IIx Movie/Music/Game
decoder is activated.
Note
Dolby Pro Logic IIx decoding does not function
for DTS format signals or for signals with a
sampling frequency of more than 48 kHz.
F DTS-ES 96/24: “DTS” lights up when DTS
signals are input. “DTS-ES” lights up when
DTS-ES signals are input. “DTS 96/24” lights
up when the receiver is decoding DTS 96 kHz/
24 bit signals.
Note
When playing a DTS format disc, be sure that you
have made digital connections and that INPUT
MODE is not set to “ANALOG” (page 35).
G NEO:6: Lights up when DTS Neo:6 Cinema/
Music mode decoding is activated.
H Tuner indicators: Lights up when using the
receiver to tune in radio stations, etc. See
pages 23–26 for tuner operations.
Note
“RDS” appears for models of area code CEL,
CEK only.
I D.RANGE: Lights up when dynamic range
compression is activated (page 36).
J COAX: Lights up when the source signal is a
digital signal being input through the
COAXIAL terminal or when
INPUT MODE is
set to “ COAX IN ” (page 35) .
K OPT: Lights up when the source signal is a
digital signal being input through the
OPTICAL terminal or when
INPUT MODE is
set to “ OPT IN ” (page 35) .
L SLEEP: Lights up when sleep timer is
activated.
About the indications in the display
L C R
SL
SB
S SR
LFE SP A DIGITAL EX PRO LOGIC IIx DTS-ES NEO:6 RDS
D.RANGE STEREOMONO SLEEP OPT COAX 96/24 SP B
; ;
MEMORY SW
9 qs
qd
q; qa
2 1 4 3 5 6 7 8
GB01COV_HT-DDW870-UCA.book Page 28 Monday, December 20, 2004 2:00 PM