Sony DCM-M1 User Manual
Page 8
(*)
Checking "Never dial a
connection" of "Internet
Options" will prevent this
window from appearing.
Such a setting, however,
requires a manual
connection to the desired
Internet access point on
"Dial-up Networking".
Note!
When you switch the connection of your PC to the MD DISCAM
from the Internet,
make sure to disconnect the Internet first and then
connect your PC to the MD DISCAM.
1. Make sure that the Internet is disconnected first and then start the
Web browser.
2. When the DIAL-UP window appears and the PC starts dialing
automatically, press "Cancel".
(*)
3. Then, input the address (e.g. 192.168.0.10) of the MD DISCAM
into the browser to access.
1. Start the Web browser.
2. The DIAL-UP window appears and the PC starts dialing
automatically .Continue to make an ordinary Internet connection.
*Apology and correction
The setting procedures described in the Instruction Manual has
been is partially corrected. (Only for
Windows95/WindowsNT4.0)
When a gateway is set on the PC, browser and
e-mail cannot be used At times, even after dialing-up. In that
case, delete the setting of the gateway on the TCP/IP
configuration of the LAN.
Users who are going to make settings are suggested to leave the
column of the gateway for TCP/IP configuration of the LAN
blank. Follow the instruction of the provider to set the gateway
of TCP/IP for DIAL-UP.
Unless otherwise specified, the setting of the gateway of the
MD DISCAM is "0.0.0.0".