Sony DCR-TRV900 - Manual (Page 25)

25
Advanced operations
Advanced operations
Using alternative power sources
You can choose any of the following power sources for your camcorder: battery pack, house
current, and 12/24 V car battery. Choose the appropriate power source depending on where
you want to use your camcorder.
Place Power source Accessory to be used
Indoors House current Supplied AC power adaptor
Outdoors Battery pack Battery pack NP-F330 (supplied), NP-F530, NP-F550, NP-
F730, NP-F730H*, NP-F750, NP-F930, NP-F950
In the car 12 V or 24 V car battery Sony DC adaptor/charger DC-V700
* NP-F730H is sold only in the U.S.A.
Note on power sources
Disconnecting the power source or removing the battery pack during recording or playback
may damage the inserted tape. If this happens, restore the power supply again immediately.
Using the house current
To use the supplied AC power adaptor:
(1) Open the DC IN jack cover, and connect the AC power adaptor to the DC IN jack
on the camcorder.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to a wall outlet.
WARNING
The power cord must be changed only at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (house current) as long as it is
connected to the power cord, even if the set itself has been turned off.
Note
Keep the AC power adaptor away from the camcorder if the picture is disturbed.
2, 3 1